Behringer Um2 Windows 10

MXL 770 Cardioid Condenser Microphone for Vocals and String Instruments Bundle with Behringer U-PHORIA UM2 USB Audio Interface for Windows and Mac, Blucoil Boom Arm Plus Pop Filter, and 10' XLR Cable 4.0 out of 5 stars 27. These interfaces include the UMC22, UM2, UCA222, and UCA202. Check out our ASIO4All setup guide for instructions on how to install and configure it. Watch the above video to install the Behringer Windows driver. From your Windows taskbar, right-click the sound icon and select Playback devices. Select your audio interface. Then, click Set Default. Click OK to close the menu. Windows 10 Sound settings can also be accessed from the Control Panel or simply by searching Sound. I just managed to get Behringer UM2 and UMC22 audio interfaces working with Jamkazam on Windows10 on Lenovo T520 (at least in a solo session, together with jamtracks). Those interfaces do not come with a specific ASIO driver, but simply rely on the generic Asio4All (asio4all.org). On a Windows machine, this driver has to be installed.

Behringer Um2 Drivers For Windows 10

Behringer
04-12-2020, 11:55 PM

Behringer Um2 Setup Driver On Windows 10

I bought the Behringer UM2 interface, since I really only needed the one port for input from my Roland TD-15, which I run thru a Mackie 1402 (along with a condenser mic for chat) and into the UM2. I was dismayed when I found out the driver I had to use was ASIO4ALL, as that is what JamKazam says NOT to use, but it's what Behringer pointed me to, so I downloaded an installed it - see attachment for latest settings used. BTW running on Lenovo laptop w/ Windows 10.
On my numerous attempts to setup my Audio Gear in JamKazam, I have never been able to get it to work cleanly when I select ASIO4ALL. on initial setup, it can't determine latency and I have to go to loopback Test page, where (when the test works at all) latency is around 3-4ms, but I/O usually fails test and I can't proceed. Occasionally, for reasons I do NOT understand, it does pass the I/O part too and I am able to add that audio gear setup and then open a solo session. However, the audio in the solo session is either really bad, with lots of noise and odd sounds, plus I see lots of output jitter - but the latency is good (under 5), OR the sound is very intermittent, meaning I can tap one of the drums and only 1 note out ten come thru. (Direct Monior is OFF on interface). I also frequently hear a faint popping sound during setup.
I have disabled the on-oard audio devices, so that only the USB Codec device (which is the interface) is active and set both input and output sampling to 48K Hz (have also tried 41K).
I have alternatively been able to setup my audio by selecting USB Codec using the default WMD driver and jam, but my internal latency is ALWAYS 20ms, so that is not ideal.
I am debating tossing the Berhinger UM2 and buying the Focusrite Scarlett 2i2 3rd Gen, but I have also seen some posts where that seems to have problems on Windows 10 and I think I might have seen one where it said that had to use ASIO4ALL too, in which case I am not buying it, if that is true.
Wondering if anyone has been able to get ASIO4ALL working with any Berhinger interface, especially the UM2? Or is there another ASIO driver I can use?